headlight.parts

As an Amazon Associate and an eBay Partner Network affiliate, we earn from qualifying purchases. Learn more

Tail Lights For Every Vehicle

Tail light assemblies, LED tail lights, and brake/rear lights that boost rear visibility and refresh the look of the back end on cars, trucks, and SUVs.

4 guides · eBay Motors searches

Shop Tail Lights Live eBay Motors Searches, Seller-Set Prices

Browse every live “tail lights” listing on eBay →

We track no Amazon listing in tail lights today; new parts are added daily. The eBay Motors shelf above is the live market for tail lights for Every Vehicle.

What You’re Actually Shopping For

A tail light isn’t one part — it’s four lamps sharing a housing: the dim running lamp, the bright brake lamp, the turn signal, and the reverse lamp, each on its own circuit and often its own bulb. Some housings run a combined dual-filament bulb (the 1157/3157/7443 family) for tail-plus-brake; others give each job its own single-filament bulb. That split is why a manual’s bulb chart lists several numbers per corner instead of one — see the full reference in Tail Lights Explained.

Tail lights split across two different markets, and it matters which one you shop. The housing is a vehicle-specific body part — lens shape, mounting points, and connector pin count are all model- and often trim-specific — which is why a used OEM assembly (the eBay Motors listings above) is usually the safer fit for older or discontinued vehicles than a universal aftermarket unit. The bulbs, flasher relays, and load resistors that go inside any housing are universal by number, not by vehicle, so those are a straightforward catalog buy in Bulbs and Wiring & Harnesses.

We don’t currently carry any Amazon-stocked tail-light assemblies — real body parts for a specific make and model don’t fit a general affiliate catalog, which is exactly why the eBay Motors rail above is the primary source for this category. Going LED on a turn signal? Budget for the hyperflash fix (an electronic flasher relay or a load resistor) before you install — the factory relay reads an LED’s lower current draw as a burnt-out bulb and doubles the blink rate until you fix it. Walkthrough in the same guide.